Description
Product description
Step 1：Split apart the wire for landscape light (A) about 1 inch, pass the wire through screw cap (B) and wire sleeve (C) until it reaches the end of the silicon seal 1
Step 2：Inset the group unit (ABCD) to the side-hole connector (E), make sure the ends of two lighting wire touch at right place by aligning flat side with the inner flat side on the side-hole connector (E) unit’s hole, tighten the screw cap(B). Note: by tightening the screw cap (B), it will make ensure the wire ends. closely contact the copper pin and seal.
Step 3：Open the locker handle (H) by turning to arrow direction, put the main wire (G) into the silicon seal 2 (F); make sure you can see the two flat pin pier comes out through the two flat holes on the Silicon seal 2 Note: Use the thinner silicon seal (F) for 12AWG main wire and the thicker silicon seal for 14/16AWG main wire.
Step 4：Make sure your transformer output is ON. Tightly turn the Locker handle (H) to closed direction. You will see the light just ON, so connection is set.
Rosie B –
The instructions took me some time to figure out. Now that I know it’s easy but it would be helpful if there was a video.
Sudby K –
Great connector, easy to use. Price is ok. There;s cheapper connectors out there but they are cheap meaning the quality is low but these are built tough.
Sarah B –
Connectors arrived quick in only 2 days as I’m in NJ and the company warehouse is in Philly.
Great product, very unique.
Chris Hattergun –
Awesome connectors! And thanks Khan Tech customer service for helping me install.
P.S. I bought on ebay first https://www.ebay.com/itm/324232946003 but found there site when I needed help with installing and I wish I bought here cuz its cheaper.